Home Assistant sends alerts by email and SMS. Most can be switched on or off individually, under a master switch, on the Alerts dashboard; a Send Test Alert button checks that messages get through. Phone numbers and email addresses are set in Home Assistant's private settings file.
Last checked against the Fairhaven configuration: 7 November 2026.
Selectable alerts (Fairhaven)
| Alert | Sent when |
|---|---|
| Master enable | Turns all the alerts below on or off |
| External temperature above 47 °C | The outside temperature passes 47 °C |
| Pump started | The pump starts |
| Water below 1 m | The tank falls below 1 m |
| Embers detected | The ember detector has been triggered for 10 seconds; at most once every 15 minutes |
| No data from shed | AR1 has received no data from the pump shed for over a minute, or has stopped reporting; at most once every 6 hours, with a second message when data returns |
| Pump stop retry | The pump still seems to be running 45 s after a stop command and a second stop is sent. Known issue: this check cannot trigger at present - see Output Control and Safety Interlocks |
| Internet reconnected | The internet connection returns after an outage |
System alerts
These are not switched from the Alerts dashboard; each is limited so a lasting fault doesn't flood your phone.
| Alert | Sent | Limit |
|---|---|---|
| Backup communications link in use | Email when AR1 switches to the backup link | At most every 15 minutes |
| RS-485 link failed (Fairhaven) | SMS, with a link to acknowledge it | At most once a day; re-arms after 30 minutes of normal operation |
| Temperature sensor failed | Email after 2 minutes, and again on recovery | At most every 12 hours |
| Tank level estimated (gauge failed) | Email after 2 minutes, and again on recovery | |
Tips
- Top up the mobile credit on the router and pump-controller SIM cards when fire danger is high (see Camera and apps).
- If alerts stop arriving, use Send Test Alert, then check the internet connection (Troubleshooting).
<< VIDEO CAMERA & COMPANION APPs | | Autonomous mode >> |Table of Contents>
