Supporting documents (PDF). Some are records from earlier stages and are marked as such; the wiki pages are the current description.

Last checked: 7 November 2026.

No.TitleNote
1The pumpGarpen WP3DELHPS
3The VYRSA sprinklers
4Pope heavy-duty impact sprinkler (12.5 m radius)
5Bushfire external water spray systems: AS 5414 design overview
6Other systems considered, and references
7Australian Standard discussion
8The pump control module (SFS01)
9Early gel injection designSuperseded - see The Gel Injection System
11Motorised valves
11AArduino pin allocationsA wiki page
12Protection for shared relay and sensor linesRelates to a design in which two Arduinos shared relay lines (see Development history: the electronics)
13Using the Teltonika RUT240 in bridge mode as a failback for the FritzboxGeneral set-up notes. As installed, the RUT240 connects to the Fritzbox by USB; failover after 10 minutes of NBN failure, back after 20 minutes (see The Electronic Control Sub-System)
14Surface temperature dynamics during wildfire approach and departure
15ARMAC system softwareEarlier record; for the current code see The code
16Shed cooling thermostat mode
17Programming implementation detailsEarlier record
18Sprinkler cycle logicSee Output Control and Safety Interlocks
19The current fire threats modelSee also Current Fire Threats Calculations and Coding
20The Pyrotector ember detectorSee Ember detector (planned)
21Metric and imperial pipe dimensionsThe PDF was never uploaded - to add

<< The code | | TestSys >>      |Table of Contents>


Page last modified on November 08, 2026, at 01:32 AM