Autonomous Mode - a mind of its own!
'Even if all of the communication is lost – mobile net and wifi power off, the mains power goes down, and the water mains turn off, do not despair – the system has a mind of its own and its own resources. A powerful HC44 battery supplies power, water is in the tank, and two Arduino micro computers in the shed monitor the engine oil pressure, pump water pressure, and other sensors. They are programmed to do the following (the parameters can be changed to suit):
- If outside communication is lost then it will proceed to follow a detailed set of protocols depending on the internal temperature of the pump shed (>60 deg switches shed cooling on) and external temperature (>60 deg switches the pump on at reduced flow and running the sprinklers intermittently (3min on, 7 min off).
- As temperature rises the sprinkling becomes more frequent and once the external temperature exceeds 80 deg the sprinklers run continuously at high flow. Once the external temperature starts to decline the system goes back to reduced flow, then intermittent, and finally stops.
- The system also monitors the water level, changing its rates of water application depending on the amount of remaining water. If the water level gets very low, then the system sprays fire-retardant gel before stopping the pump. (Since the gel pump is made of plastic, it sits on a side branch with a solenoid on the inlet side and a check valve on the outlet side, so that if it fails the sprinklers are unaffected.)
- If sensors are lost the system compensates where it can. For example, if the water level sensor is lost the system calculates the remaining water utilising the flow sensor. If the flow sensor is also lost the system assumes the last measured flow rate to keep track of the remaining water. If all key sensors are lost, the system goes through a pre-programmed routine, continuing from the state of play when the loss occurred.
- Battery voltage is monitored and while it is good (>12.0 volt) for the longer intermittent cycles (more than 15 minutes off) it achieves those by turning the pump off and back on, but if the voltage reduces further, or no battery reading is available, the battery is conserved by leaving the pump on and turning the flow on, or alternative through a recycling valve back to the tank. Full details of the decision matrix are given in the Technical Notes.
- If communication with the outside world resumes the system texts the operator allowing the operator to resume manual mode at will.
- In Autonomous mode, the various changes being automatically initiated can be tracked in both the Module 4 LCD screen and also in the Autonomous Dashboard panel.
Taking back control. Switching Autonomous Mode off returns control to the dashboard in about 15-20 seconds. Manual control then starts with the pump, sprinklers, high flow and gel off (the shed cooling setting is kept), so turn the pump back on if it is still needed. The details are in The Heartbeat System and Mode Transitions and Autonomous Fire Defence Algorithms.
<< Alerts | | The Current Fire Threats Dashboard >> |Table of Contents>

